firewalld
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
firewalld [2019/05/01 09:31] k2patel [Adding rich rule] |
firewalld [2019/05/01 11:12] (current) k2patel [Port redirection] |
||
|---|---|---|---|
| Line 30: | Line 30: | ||
| Using following command one can redirect port traffic to another. | Using following command one can redirect port traffic to another. | ||
| <code bash> | <code bash> | ||
| + | # iptables -t nat -A PREROUTING -i eth2 -p tcp --dport 8080 -j REDIRECT --to-port 8443 | ||
| firewall-cmd --permanent --direct --add-rule ipv4 nat OUTPUT 0 -p tcp -o lo --dport 8080 -j REDIRECT --to-ports 8443 | firewall-cmd --permanent --direct --add-rule ipv4 nat OUTPUT 0 -p tcp -o lo --dport 8080 -j REDIRECT --to-ports 8443 | ||
| </code> | </code> | ||
firewalld.txt ยท Last modified: 2019/05/01 11:12 by k2patel
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
