firewalld
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
firewalld [2018/09/28 16:52] k2patel [Replace firewalld with iptables] |
firewalld [2019/05/01 13:31] k2patel [Adding rich rule] |
||
|---|---|---|---|
| Line 25: | Line 25: | ||
| source address="192.168.12.0/25" | source address="192.168.12.0/25" | ||
| port protocol="tcp" port="9200" accept' | port protocol="tcp" port="9200" accept' | ||
| + | </code> | ||
| + | |||
| + | ==== Port redirection ==== | ||
| + | Using following command one can redirect port traffic to another. | ||
| + | <code bash> | ||
| + | firewall-cmd --permanent --direct --add-rule ipv4 nat OUTPUT 0 -p tcp -o lo --dport 8080 -j REDIRECT --to-ports 8443 | ||
| </code> | </code> | ||
firewalld.txt ยท Last modified: 2019/05/01 15:12 by k2patel
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
