User Tools

Site Tools


opensuse

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
opensuse [2009/04/17 15:43]
k2patel created
opensuse [2020/08/10 02:35] (current)
Line 5: Line 5:
  
 <code text> <code text>
-NOTE : change "​Internal_ip"​ "​Tunnel_broker_ip"​ "IPv6" "​IPv6_gateway_ip"​ with information you get from your broker+NOTE : change "​Internal_ip"​ "​Tunnel_broker_ip"​ "IPv6_ip" "​IPv6_gateway_ip"​ with information you get from your broker
 </​code>​ </​code>​
  
Line 14: Line 14:
 TUNNEL_LOCAL_IPADDR='​Internal_ip'​ TUNNEL_LOCAL_IPADDR='​Internal_ip'​
 TUNNEL_REMOTE_IPADDR='​Tunnel_broker_ip'​ TUNNEL_REMOTE_IPADDR='​Tunnel_broker_ip'​
-IPADDR='​IPv6'+IPADDR='​IPv6_ip'
 TUNNEL_TTL='​64'​ TUNNEL_TTL='​64'​
 </​code>​ </​code>​
Line 22: Line 22:
 </​code>​ </​code>​
  
-  ​Now turn on the ipv6 using ipup sit1+  ​Now turn on the ipv6 using "​ifup ​sit1"
  
 You should be good to go You should be good to go
 +
 +==== Load Kernel module at boot ====
 +
 +From previous wiki, if you reboot system you lost your tunnel.\\
 +The only reason is you have no longer sit.ko (sit module) loaded to kernel.
 +
 +There is two way to enable kernel module to suse - GUI and Editor
 +
 +<code text | GUI>
 +    * Open YaST and authenticate,​ if necessary.
 +    * Navigate to System > /​etc/​sysconfig Editor
 +    * Navigate to System > Kernel > MODULES_LOADED_ON_BOOT
 +    * Enter a list of modules to load at startup, separated by spaces.
 +    * Click Finish when done.
 +    * Confirm the modified variables and click OK.
 +</​code>​
 +
 +<code text | Editor>
 +    * Use a superuser or root shell 
 +    * Open a text editing tool, such as vim or nano to edit the /​etc/​sysconfig/​kernel file.
 +    * Find the line starting with: MODULES_LOADED_ON_BOOT
 +    * Between the quotes, enter the modules you wish loaded at boot time, separated by spaces.
 +    * Save the file and exit the editor.
 +</​code>​
 +
 +Type in the following command: ​
 +<code bash>
 +SuSEconfig
 +</​code>​
 +The module(s) will now load at startup. ​
opensuse.1239983000.txt.gz ยท Last modified: 2020/08/10 02:30 (external edit)