# This is an example resource file for rTorrent. Copy to         
# ~/.rtorrent.rc and enable/modify the options as needed. Remember to
# uncomment the options you wish to enable.                          
safe_sync = yes                                                      

# Maximum and minimum number of peers to connect to per torrent.
#min_peers = 40                                                 
#max_peers = 100                                                

# Same as above but for seeding completed torrents (-1 = same as downloading)
#min_peers_seed = 10                                                         
#max_peers_seed = 50                                                         

# Maximum number of simultanious uploads per torrent.
#max_uploads = 15                                    

# Global upload and download rate in KiB. "0" for unlimited.
download_rate = 2000                                        
upload_rate = 750                                           

# Default directory to save the downloaded torrents.
directory = /media/harddisk3/home/jason/images2     

# Default session directory. Make sure you don't run multiple instance
# of rtorrent using the same session directory. Perhaps using a       
# relative path?                                                      
session = ~/rsession                                                  

# Watch a directory for new torrents, and stop those that have been
# deleted.                                                         
schedule = watch_directory,5,5,load_start=/media/harddisk3/home/jason/images2/*.torrent
#schedule = untied_directory,5,5,stop_untied=                                          

# Close torrents when diskspace is low.
schedule = low_diskspace,5,60,close_low_diskspace=100M

# Stop torrents when reaching upload ratio in percent,
# when also reaching total upload in bytes, or when   
# reaching final upload ratio in percent.             
# example: stop at ratio 2.0 with at least 200 MB uploaded, or else ratio 20.0
#schedule = ratio,60,60,"stop_on_ratio=200,200M,2000"                         

# The ip address reported to the tracker.
#ip = 127.0.0.1                          
#ip = rakshasa.no                        

# The ip address the listening socket and outgoing connections is
# bound to.                                                      
#bind = 127.0.0.1                                                
#bind = rakshasa.no                                              

# Port range to use for listening.
#port_range = 6890-6999           

# Start opening ports at a random position within the port range.
#port_random = no                                                

# Check hash for finished torrents. Might be usefull until the bug is
# fixed that causes lack of diskspace not to be properly reported.   
#check_hash = no                                                     

# Set whetever the client should try to connect to UDP trackers.
use_udp_trackers = yes                                          

# Alternative calls to bind and ip that should handle dynamic ip's.
#schedule = ip_tick,0,1800,ip=rakshasa                             
#schedule = bind_tick,0,1800,bind=rakshasa                         

# Encryption options, set to none (default) or any combination of the following:
# allow_incoming, try_outgoing, require, require_RC4, enable_retry, prefer_plaintext
#                                                                                   
# The example value allows incoming encrypted connections, starts unencrypted       
# outgoing connections but retries with encryption if they fail, preferring         
# plaintext to RC4 encryption after the encrypted handshake                         
#                                                                                   
# encryption = allow_incoming,enable_retry,prefer_plaintext                         

# Enable DHT support for trackerless torrents or when all trackers are down.
# May be set to "disable" (completely disable DHT), "off" (do not start DHT),
# "auto" (start and stop DHT as needed), or "on" (start DHT immediately).    
# The default is "off". For DHT to work, a session directory must be defined.
#
#dht = off

# UDP port to use for DHT.
#
# dht_port = 6881

# Enable peer exchange (for torrents not marked private)
#
# peer_exchange = yes

#
# Do not modify the following parameters unless you know what you're doing.
#

# Hash read-ahead controls how many MB to request the kernel to read
# ahead. If the value is too low the disk may not be fully utilized,
# while if too high the kernel might not be able to keep the read
# pages in memory thus end up trashing.
#hash_read_ahead = 10

# Interval between attempts to check the hash, in milliseconds.
#hash_interval = 100

# Number of attempts to check the hash while using the mincore status,
# before forcing. Overworked systems might need lower values to get a
# decent hash checking rate.
#hash_max_tries = 10